White privacy fence9/12/2023 Before moving onto the next phase, go back over what you have just done with the next coat before moving on to the next phase. To avoid difficulties it is good practice to acknowledge how much time you can commit to a project in one straight run and not to attempt too much Divide the task into hourly chunks and paint the first coat on a section of the project, perhaps one or two sides of the shed. Instead it is better to paint sections in in time chunks of 2-4 hours. Don't try to coat the whole project with one coat before getting onto the next coat. If wood has been exposed and dried out for a long period of time, this may also draw the more of the product away from the surface and into the wood structure.īe mindful that it is waxed-enriched and that once these waxes are dried, they act to repel liquids, which would include an additional coats. This may be noticeable with rougher woods, open end grains or indeed deep colours. The product will still achieve good opacity in 2 coats over a similar colour, although deeper colours may require a third coat.Īs Garden Shades often goes on directly to the wood, without a primer, sometimes it will soak deep into the wood and this can create the need for a third coat. As its sprayable, it also needs to be of low viscosity and will be runnier than other traditional paints. It is free-flowing to enable a smooth finish that gets into all the gaps and allows the profile of the wood to be a maintained. Garden Shades is a relatively thin and slack product by design. I have purchased Garden Shades and it seems extremely runny and watery. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent. Cover any nearby surfaces in case of overspray. Refer to the Sprayer user guide for full instructions before every use. Stir thoroughly before pouring contents into the Cuprinol sprayer. Brush on product, evenly, along the grain. Make sure wood has been pre treated with appropriate wood preserver to prevent wood and decay.Ĭoverage can vary depending on application method and the condition and type of surface. If adhesion is inadequate on previous coatings, lightly sand before application. The final colour will vary depending on the surface and number of coats. IF NOT POSSIBLE, LIGHTLY SAND DOWN SURFACES BEFORE RECOAT TO ENSURE ADHESION.Īpply in dry conditions, above 5 degrees Celsius and when bad weather is not forecast, minimum of 2 coats required. SUBSEQUENT COATS MUST BE APPLIED ON THE SAME DAY NO LONGER THAN 8 HOURS APART.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |